Vol1 Ch22 OSPF Basics

OSPF uses a router’s Router ID (RID) to identify each router. We see the RID in many OSPF verification commands, so using predictable, known OSPF RID values can help people operate [...]

A router configuration can enable OSPF on an interface directly using the ip ospf interface subcommand. In fact, the configuration is more direct and obvious than the old traditional use of the [...]

When using the OSPF network command, whether single area of multi-area, you have to be careful with the wildcard mask used and which interfaces each network command matches. With multiple areas, [...]

What if your #CCNA exam required you to configure the OSPF network command with a particular style of mask? What if it said “match all addresses in the subnet”, or “match all addresses in the [...]

The OSPF network command can cause a bit of mental trouble for anyone just starting out. The reason: the first two parameters require us to do a little math, compare that result to the router’s [...]

It’s too easy – enabling OSPF per interface rather than using the old IOS network command. In some ways, we may not trust that it’s that easy. So get some practice with today’s lab, a nice clean [...]

From the first days of OSPF in Cisco routers, OSPF configuration has included a network command. The network command enables OSPF on that router’s interfaces, but it uses indirect logic. In fact, [...]